FPGA Central - World's 1st FPGA / CPLD Portal

FPGA Central

World's 1st FPGA Portal


Go Back   FPGA Groups > NewsGroup > FPGA

FPGA comp.arch.fpga newsgroup (usenet)

LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 11-07-2003, 11:11 AM
Posts: n/a
Default spartan 3 queries

I am designing a board using spartan3 1.5million device. I got few
1. I am planning to configure the device using a host DSP. The
interface is 3.3 V and slave serial mode. I am connecting a series
resistor between the DSP dicrete & PROGB of FPGA to make it tolerant
and so for CCLK and DIN. I am pulling DONE INIT to 3.3 V for the same
reason. Am I correct i this?
2. Please suggest suitable decoupling for the power supply.

Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
PLI : some stupid queries. Monika Talwar Verilog 0 02-25-2004 12:17 PM

All times are GMT +1. The time now is 09:36 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.2.0
Copyright 2008 @ FPGA Central. All rights reserved