FPGA Central - World's 1st FPGA / CPLD Portal

FPGA Central

World's 1st FPGA Portal

 

Go Back   FPGA Groups > NewsGroup > FPGA

FPGA comp.arch.fpga newsgroup (usenet)

Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 07-08-2003, 12:44 AM
John
Guest
 
Posts: n/a
Default Re: [DLL usage Virtex/Spartan-II] HowTo drive CLKDV Div 2 off Chip

Be carefull. Usually when you instantiate a ibufg, you are actually
instantiating a IOB configured as an input, and a bufg. You only want to use an
IOB as the input and make sure it is loc'd to a clk input pin location.

As for your div/2, you can divide the input to the dll by 2 using the
CLKIN_DIVIDE_BY_2 parameter. Don't know if this helps because the clk0 will be
div/2 since the dll is dividing the input to the dll.





Markus Meng wrote:
> Hi All,
>
> some notes I could not figure out directly from one of the XAPP132, 174
> from Xilinx. If I want to drive an Off-Chip device with half of the clkin
> frequency
> without using a GBUF driver, can I feedback the devided signal from the obuf
> driving the pin through an IBUFG and still having the DLL functionality of
> phase
> shift an duty cycle correction. I read that the feedback signam MUST be
> clkout
> or 2xclkout. The problem is that I am running out of GBUF's in my design ...
>
> markus
>



Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Re: SPARTAN-3 vs. VIRTEX-II rickman FPGA 9 07-09-2003 06:10 AM


All times are GMT +1. The time now is 11:34 AM.


Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.2.0
Copyright 2008 @ FPGA Central. All rights reserved