FPGA Central - World's 1st FPGA / CPLD Portal

FPGA Central

World's 1st FPGA Portal

 

Go Back   FPGA Groups > NewsGroup > FPGA

FPGA comp.arch.fpga newsgroup (usenet)

Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 10-17-2003, 01:32 PM
Bart
Guest
 
Posts: n/a
Default program a Lattice MACH211

I need to program an obsolete Lattice component, the MACH211-15JC.
I would like to do this with the software tool ispLEVER v3.0
Problem is that I cannot select that device out of the list with the
available devices.

In ispLEVER I can choose for the MACH211SP, but (in my case) I can't
use it.
The MACH211SP is ISP and there are pin 13 and 35 (and another few)
reserved for JTAG configuration.

I need absolutely to program the MACH211-15JC because I have to
reprogram the device which is used in an older hardware application.
And of course, I need pin 13 and 35 as input ports.

So question is, which device do I have to select, or are there some
files which I have to install to make the device available in the
list.

So if anyone can help me, I would appreciate it very well.
Bart
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
How do I use Lattice Mico32's debug-engine on a non-Lattice FPGA? Ssa Verilog 1 07-19-2007 06:26 PM


All times are GMT +1. The time now is 10:32 AM.


Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.2.0
Copyright 2008 @ FPGA Central. All rights reserved