Multilinx, where do I get 3.3V power?
 

I am using MultiLinx to program my XC2V1000 thru JTAG connector.
I got TMS, TCK, TDI, TDO correctly, but unable to find the 3.3V and GND.
Without this 3.3V, I can detect devices on two out of three JTAG ports on my
board, and I need the third port to work.

I am applying a 2.5V on the PWR & GND of the SelectMAP(?) connector on
my Multilinx and it drew 0.9A power. I am unable to find another power
supply
to make 3.3V now. :(

What can I do with this situation?

Thanks

Re: Multilinx, where do I get 3.3V power?
 

My mistake, MultiLINX runs from 2.5V - 5.0V, thus 3.3V solves my problem.



"Francis" <[email protected]> wrote in message
news:[email protected]
> I am using MultiLinx to program my XC2V1000 thru JTAG connector.
> I got TMS, TCK, TDI, TDO correctly, but unable to find the 3.3V and GND.
> Without this 3.3V, I can detect devices on two out of three JTAG ports on
my
> board, and I need the third port to work.
>
> I am applying a 2.5V on the PWR & GND of the SelectMAP(?) connector on
> my Multilinx and it drew 0.9A power. I am unable to find another power
> supply
> to make 3.3V now. :(
>
> What can I do with this situation?
>
> Thanks
>
>
>
>