FPGA Central

World's 1st FPGA Portal

		FPGA Groups > NewsGroup > FPGA
-mapstyle option in BATCH mode operation of XST

FPGA comp.arch.fpga newsgroup (usenet)

LinkBack

Thread Tools

Display Modes

#1 (permalink)

06-23-2004, 04:00 PM

Varun

Guest

Posts: n/a

-mapstyle option in BATCH mode operation of XST

hello,

While running the XST in batch mode;

(by typing xst at command prompt) .. and followed by "help -arch virtex -command run" .... this gives a list of all the synthesis options available in the batch mode.

one of the options is -mapstyle... which has two options to select from (LUT / Library) ...

this option is not described in software documentation, as well not found in GUI.

Does anybody have any information regarding the purpose of this option?

thanks in advance.

regards
Varun.

Bookmarks

« ANN: Low cost & high speed JTAG interface | Re: New: read/write to D2SB fpga »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PLI tab file and misc option	[email protected]	Verilog	1	06-21-2007 04:35 PM
Modelsim simulation progress in batch/command line mode?	Andreas Ehliar	Verilog	6	04-26-2007 07:05 PM
Does IBUFDS_DIFF_OUT with -DT option exist?	qlyus	FPGA	0	04-10-2004 03:01 AM

All times are GMT +1. The time now is 06:08 PM.