View Single Post
  #2 (permalink)  
Old 05-01-2006, 05:28 PM
John_H
Guest
 
Posts: n/a
Default Re: ERROR:iMPACT:1210 - '1':Boundary-scan chain test failed at bit position '1'

Which programming cable are you using to interface to the JTAG?
What reference voltage into the programming cable are you using at the board
interface?

"boru" <[email protected]> wrote in message
news:[email protected] oups.com...
> hi everyone,
> i am curently debugging a board developed havin vitex chip... when i
> try to program this board following error occurs.
>
> ERROR:iMPACT:1210 - '1':Boundary-scan chain test failed at bit position
> '1'
>
> i tried to go through the xilinx website and found some instruction but
> that did not help ..
> if any one encountered the same problem .... your help will be
> appreciated......
>
> One of the reason I am thinking is the the speed with which the virtex
> chip and Jtag are operating are not matching, correct me if I am wrong.
> If yes is there anyway to change frequency of JTAG.
>



Reply With Quote