View Single Post
  #1 (permalink)  
Old 04-02-2004, 06:39 PM
PO Laprise
Guest
 
Posts: n/a
Default Verifying multi-cyclicity of multi-cycle paths

Ok, here's a small variation on a previous post. My design is giving
the wrong results in post-PAR simulation (no SDF errors or warnings, no
timing violations in PAR), and I want to verify whether my multi-cycle
paths are to blame. I would prefer to check this using behavioural code
rather than the post-PAR model, because the latter takes days to run my
complete testbench. How would you go about this? Post-PAR suggestions
are also welcome, as are any other ideas as to the possible causes of
such a discrepancy. Thanks in advance...

--
Pierre-Olivier

-- to email me directly, remove all _N0SP4M_ from my address --

Reply With Quote