 |
FPGA CentralWorld's 1st FPGA Portal |
|
|
|
|||||||
| FPGA comp.arch.fpga newsgroup (usenet) |
|
|
|
 |
|
|
LinkBack | Thread Tools | Display Modes |
06-29-2005, 03:17 PM
|
|||
|
|||
Quatech SPP-100 programs/verifies successfully but device is not "programmed"
I am using the Quatech SPP-100 PCMCIA parallel port emulator with a
Dell M70. Everything looks great. When I program the PROM (XCF08S) it programs and verifies successfully. The FPGA does not get programmed correctly however by the PROM on power up. Then I tried programming the FPGA, Virtex 4 FX12, and same thing, programs and verifies successfully but does not run. Then I tried programming the FPGA without verification. Then it works fine. I tried the PROM without verification with no success. It seems the only thing that I can do is program the FPGA without verification. By the way the same program runs fine when programmed from a different machine with a dedicated parallel port. Anyone seen this before and if so any possible solutions? Cheers, irish 
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to represent "inout" data type in testbenches in "verilog" | linuxczar | Verilog | 2 | 03-21-2007 07:28 PM |
| Why do we need "check" "call" "misc" in PLI? | Lee | Verilog | 1 | 05-17-2004 04:42 PM |
| "clean" or "unprotected" versions of AHDL2X, SYNTHX from Xilinx (ABL2XNF sub tools) | Bill Smith | FPGA | 0 | 11-11-2003 12:17 AM |
All times are GMT +1. The time now is 03:01 AM.
