FPGA Central

#1 (**permalink**) 06-04-2006, 01:31 PM

hi all, few days a go I updated my ISE8, now I have ISE Foundation
8.03i and the problem is when I want to perform a multi place an route,
it falls and I get an error : "Process "Place & Route" failed"

as a simple solution, I performed a simple place and route, after if my
constraints are not met, I change the cost table manually. my question
is : is it a bug in the service pack 3? also,
Is there another way to this automaically ? thanks in advance. Nezhate

#2 (**permalink**) 06-04-2006, 01:34 PM

sorry I want to say : Multi Pass Place and Route. sorry again!

#3 (**permalink**) 06-05-2006, 05:37 PM

nezhate wrote:
> hi all, few days a go I updated my ISE8, now I have ISE Foundation
> 8.03i and the problem is when I want to perform a multi place an route,
> it falls and I get an error : "Process "Place & Route" failed"
>
> as a simple solution, I performed a simple place and route, after if my
> constraints are not met, I change the cost table manually. my question
> is : is it a bug in the service pack 3? also,
> Is there another way to this automaically ? thanks in advance. Nezhate

I normally use my own script for MPPR. The script "run_mppr" that I use
is available at http://home.comcast.net/~jimwu88/tools/ under
"Makefiles for running ISE command line tools".

HTH,
Jim

#4 (**permalink**) 06-06-2006, 07:04 AM

Jim Wu wrote:
> I normally use my own script for MPPR. The script "run_mppr" that I use
> is available at http://home.comcast.net/~jimwu88/tools/ under
> "Makefiles for running ISE command line tools".
>
> HTH,
> Jim

Thanks Jim.

FPGA Central

World's 1st FPGA Portal