FPGA Central

World's 1st FPGA Portal

		FPGA Groups > NewsGroup > FPGA
Is "Insight IJC-02" and "Xilinx parallel download cable" the same?

FPGA comp.arch.fpga newsgroup (usenet)

LinkBack

Thread Tools

Display Modes

#1 (permalink)

11-10-2007, 05:43 AM

[email protected]

Guest

Posts: n/a

Is "Insight IJC-02" and "Xilinx parallel download cable" the same?

When looking at this schematic:
http://www.xilinx.com/support/programr/jtag_cable.pdf

And comparing with the pcb layout of Insight jtag IJC-02 parallel port
dongle. They seem to be the same thing. Is that so .. ?

Any catches with it?, I saw some posts about removing C1 and
unnecessary filtering.
I assume that it's powered from the circuit to be programmed, and thus
using the 74HC125D capability to withstand +5V while powering it from
a lower voltage to make it's outputs compatible with the +2.5V or
+3.3V circuit.

(maybe next project will be Ethernet PHY+CPLD+Jtag :-)

Bookmarks

« SystemACE generation | 7000+ beautiful Russian women »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Parallel Cable IV opened in "Compatibility Mode"	Sean Durkin	FPGA	7	05-10-2005 03:02 PM
Parallel Cable IV operating in "Compatibility Mode" under linux kernel 2.6.x	Jason Wu	FPGA	1	05-08-2005 11:44 PM
"clean" or "unprotected" versions of AHDL2X, SYNTHX from Xilinx (ABL2XNF sub tools)	Bill Smith	FPGA	0	11-11-2003 12:17 AM

All times are GMT +1. The time now is 04:08 AM.