FPGA Central

World's 1st FPGA Portal

		FPGA Groups > NewsGroup > FPGA
How to use Xilinx Virtex-II Pro to read and write NAND FLASH.

FPGA comp.arch.fpga newsgroup (usenet)

LinkBack

Thread Tools

Display Modes

#1 (permalink)

10-05-2004, 01:48 PM

carter

Guest

Posts: n/a

How to use Xilinx Virtex-II Pro to read and write NAND FLASH.

Hello£¬All
I want to use this chip to read and write a NAND FLASH(SAMSUNG
K9W4G08U1M) in a speed of 100Mbps by using GPIO.but I find it very difficult
to find a reference design.And my design was fail to read and write.So I
write this E-mail just to ask you if you have experience in doing this kind
of project.I also want to know how many Mbps this chips can get in reading
and writing FLASH memroy .
BTW: If you have the same design,I am greatly appreciate that you can send
me your design and your advices.
thanks
carter

Bookmarks

« meaning of "field-programmable" in FPGA | HOw to use Xilinx Virtex-II Pro to read and write FLASH »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Xilinx Read First Write First	Brad Smallridge	FPGA	12	12-09-2004 12:28 AM
How to change Read Only Constraint to Read-Write	Isaac	FPGA	3	07-10-2003 03:43 PM
NAND flash file	[email protected]	FPGA	1	07-01-2003 09:33 PM

All times are GMT +1. The time now is 04:08 AM.