FPGA Central

#1 (**permalink**) 08-05-2004, 11:31 PM

Hey all,
Does anybody know of a good tutorial for EDK 6.2 that doesn't explicitly
use a premade dev board.
I want to create a project from scratch and add a plb buss and a few
devices to the plb buss. There are so many wires and unknowns that I
can't do this without some useful instruction manual or tutorial to copy
from.
Does this exist and if not am i crazy for asking for it?

Matt

#2 (**permalink**) 08-05-2004, 11:45 PM

Matt,
Do you have any mates at Insight? Their tutorial for Ultracontroller is
meant to run on their dev. board, but the Insight chap got it up and running
on my company's board from scratch in 2 hours.
Cheers, Syms.
"Matthew E Rosenthal" <[email protected]> wrote in message
news:[email protected]..
> Hey all,
> Does anybody know of a good tutorial for EDK 6.2 that doesn't explicitly
> use a premade dev board.
> I want to create a project from scratch and add a plb buss and a few
> devices to the plb buss. There are so many wires and unknowns that I
> can't do this without some useful instruction manual or tutorial to copy
> from.
> Does this exist and if not am i crazy for asking for it?
>
> Matt

#3 (**permalink**) 08-09-2004, 09:25 AM

This site has some very good tutorials which got my and my colleague
started with EDK.

http://www.eece.unm.edu/xup/

Although they use a ML300 board they explain very thoroughly how to
connect every signal.

Hope it helps...

With regards

// Jonas

#4 (**permalink**) 08-09-2004, 07:05 PM

Jonas,
Excellent link.
Many thanks, Syms.
"Jonas Floden" <[email protected]> wrote in message
news:[email protected]..
> This site has some very good tutorials which got my and my colleague
> started with EDK.
>
> http://www.eece.unm.edu/xup/
>

FPGA Central

World's 1st FPGA Portal