>On 11/12/2009 1:05 PM, Kevin100 wrote:
>> My group is working on a project where we need to improve the SNR of a
>> 64QAM RF channel. It is 6.4 MHz wide and the center frequency can b
as
>> high as 82 MHz. How do we go about selecting a DSP for this project?
Or
>> what would be a good DSP to use? We want to avoid doing an hardware
>> development, so ideally we would like to use a DSP development kit.
Any
>> suggestions?
>
>Without knowing how you're going to sample the signal, or what sample
>rate you might use, or a rough estimate of how many MIPS your process
>might take, I think it'd be pretty tough to even take a wild guess.
>
>--
>Eric Jacobsen
>Minister of Algorithms
>Abineau Communications
>http://www.abineau.com
>

Eric,

The sampling rate will be 170 Msps. And the latency needs to be less tha
50 microseconds. When we began this project the idea was to use an Analo
Devices ADC (AD9430, 12 bit), followed by an FPGA and and then a DAC.
However in order to speed things up I was wondering if there wer
development kits available with all these components on one board.

Thanks!
Kevin