On 11/12/2009 1:05 PM, Kevin100 wrote:
> My group is working on a project where we need to improve the SNR of a
> 64QAM RF channel. It is 6.4 MHz wide and the center frequency can be as
> high as 82 MHz. How do we go about selecting a DSP for this project? Or
> what would be a good DSP to use? We want to avoid doing an hardware
> development, so ideally we would like to use a DSP development kit. Any
> suggestions?

Without knowing how you're going to sample the signal, or what sample
rate you might use, or a rough estimate of how many MIPS your process
might take, I think it'd be pretty tough to even take a wild guess.

--
Eric Jacobsen
Minister of Algorithms
Abineau Communications
http://www.abineau.com