Sharanbr escribió:
> On Jul 1, 3:05 pm, "Symon" <symon_bre...@hotmail.com> wrote:
>> http://www.xilinx.com/itp/xilinx7/bo...gd0140_101.htm...
>
> Thanks, but I was not asking about the setting up the constraints for
> fpga pinouts, it was a larger question.
> How do I ensure that I have got a fairly accurate pinout (assuming
> meeting timing is not an issue) when
> the design is still under development. Do people create dummy FPGA top
> and use special tools that only
> check the validity of the pinouts wrt to the selected device?
>
> Look at it this way - people in S/W world exchange information about
> each other's module
> by providing the class prototypes and this happens much before the
> code has been developed.
>
> Regards,

In XILINX, PACE or PLANAHEAD, allow you to define your pintout and do a
basic ERC, but beware you must use good placement rules or you fall into
implementations errors after;

Walter