On 21 Feb, 08:14, c...@claysturner.com wrote:
> On Feb 20, 4:38*pm, Bob <sten...@yahoo.com> wrote:
>
>
>
>
>
> > On 20 Feb, 20:41, Mark <makol...@yahoo.com> wrote:
>
> > > > So now I see something,,,notice the small peak to the left of the
> > > > cursor on the second and fourth traces. Should this not be the same as
> > > > the peaks beside it?
>
> > > remember you are looking at the RRC filter..which is only 1/2 the
> > > picture
>
> > > pass this output though another RRC filter so that you have the full
> > > RC filter and you will see what the receiver sees...
>
> > > the Rx and Tx have matched filters and the NYquist filter is both of
> > > them in cascade,
>
> > > you are looking 1/2 way through the cascade..
>
> > > Mark
>
> > Hi Mark,
>
> > The pulses you see on the first link is what happens when I pass the
> > data through the RRC on the TX link. On the demod side links 2 and 3
> > are when the data from the modulator is passed through idential RRCs.
> > So, in effect I already have the RC response at the receiver. But is
> > it correct...that's what I would like to know?
>
> > Bob- Hide quoted text -
>
> > - Show quoted text -
>
> Hello Bob,
>
> The feeding of pulses into the RRC filter (via convolution) assumes
> your pulses become Kronecker deltas. Don't feed rectangular pulses,
> instead feed spikes into the RRC filter. Then after going through two
> of these in sucession, you will see a nice looking signal. You are
> currenly getting a bunch of ringing resulting from the rectangular
> pulse's response comingled (convolved) with the RRC's response. For
> simplifying the testing, just try an RC filter and look at its output.
> Two RRCs convolved is an RC. Try it!
>
> IHTH,
>
> Clay- Hide quoted text -
>
> - Show quoted text -

Hi Clay,

I did already try it. I fed the output of one RRC into another and
you're correct...I did get a nice RC pulse output.
In the test case, this was done for spikes well seperated. However,
for real test data, I don't have much choice as I have strings of 1's
and in most cases very few 0's between them. In this case, what are my
options?

Regards
Bob