Hi Andreas,
ISE 8.2 has a tcl interface and supports partitions,
Aurash

Andreas Ehliar wrote:

>I'm trying to figure out if it is possible to use partitions
>using either command line flow (I want to integrate it into a
>Makefile environment) or at least using xflow.
>
>So far I have come to the conclusion that there is no documentation
>at all on how to use it outside of Project Navigator. Something
>which also annoys me is that it seems like the entire design is
>synthesized (without any optimization I presume) every time I save a
>file in ISE if partitions are enabled. Using some -XstNtrc switch
>to xst which is not documented anywhere that I can find. And it
>seems like xst also gets an -ise switch which points to the .ise
>binary blob. (This means that it takes about a minute to save a
>small file in ISE because it waits for xst to complete...)
>
>
>/Andreas
>
>


--
__
/ /\/\ Aurelian Lazarut
\ \ / System Verification Engineer
/ / \ Xilinx Ireland
\_\/\/

phone: 353 01 4032639
fax: 353 01 4640324